How to Safely Remove Car Battery Corrosion- By: Gordon Freyman

Description : 1
Assemble Your Tools and Supplies
Gather the essential tools and supplies required to tackle this job. You will need to put on a pair of safety glasses and work gloves. Avoid wearing your good clothes as you will come in contact with grease and dirt.
You will need a stiff wire brush, a cup of lukewarm or cold water, a box of baking soda, a teaspoon and rags. An old toothbrush, pliers, a wrench and petroleum jelly round out your tools and supplies.

2
Disconnect the Battery
Park your car outside, preferably in your driveway or in the street. Lift and secure the car's hood, then locate the battery. In some vehicles the battery can be found underneath the rear passenger seat or in the trunk.
Take the wrench and pliers to the black (negative) connection or post and loosen same. Repeat this process with the red (positive) connection. Place your tools away from the battery cables to avoid contact resulting in an electrical shock.

3
Remove Car Battery Corrosion
Take your teaspoon and fill it with baking soda. Combine this powder with your cup of water and stir. Gradually pour approximately half the solution over each battery post, then place this mixture to the side.
Take your wire brush or old toothbrush and brush off the remaining corrosion. You can dip the brush into the mixture or pour the remaining amount over the terminals as needed. For tough cases allow this solution to penetrate for at least five minutes. Continue brushing until all corrosion has been removed. See: Ford: Cleaning Battery Corrosion
4
Preparation and Clean Up
Dry off the battery, wiping it down with a clean rag. Wipe down the battery cables. Discard your rag. Apply petroleum directly to each battery post liberally. Reconnect the battery cables beginning with the positive connection followed by the negative connection. Tighten each connection with your pliers or wrench.
Remove all tools and supplies, close the hood and start you car to ensure that it will run. You might also consider moving the car away from the work area and bringing out the garden hose to wash away the corrosive residue left on the ground.
Battery corrosion removal and care can be successfully handled within 15 to 20 minutes. Make this an annual task and you will avoid potential problems that can leave you stranded or shorten your battery's useful life.

Article Source : http://www.look4articles.com/

Author Resource : Noint.com